Specifications

1-11
Connecting Power Supply
Connecting Power Supply
Printer specifications
Single-phase 200 to 240 Vac 15 A or less (cannot be used with 100 V system)
For power supply connection, this printer uses the Type B plug and socket in compliance with IEC 60309.
When a socket construction meeting the plug of the power cable of this printer is required, use the supplied
socket and perform construction between your switchboard or wall outlet and the socket.
 You are not allowed to install the printer by yourself. Be sure to request
MIMAKI’s service personnel and an electrician to install the printer.
 For the power supply to the main body of the printer, electrical work is required
as described below. Request an electrician to perform electrical work.
 Ensure that a wall outlet is available near the printer. Also ensure that the
power cable can be easily unplugged whenever necessary.
 To prevent electrical shock hazard, it is prohibited for anyone other than elec-
trician licensees to perform the electrical work for this printer.
 Take care not to miswire, which can result in a fire or an electric shock.
 When any power cable other than the supplied one is to be used, make sure
that the cable is equivalent to one of the following types. Connect the cable
as shown below.
• VCT-2mm² x3 cores (600 V)
• UL-AWG14x3C (600 V)
Cable:
UL AWG14 or the equivalent
Supplied socket
Rear of the printer body
Socket
Socket construction
Switchboard or wall outlet