Specifications

6-21
BUILT-IN EXHAUST FAN
Set the operation of the built-in exhaust fan when the fan is equipped.
As a default, the built-in exhaust fan operates in conjunction with the dryness fan setting. If switched to
independent operation, different setting from the dryness fan is available.
STOP TIME
Set the time from the completion of printing to the stop of the fan.
Available setting values: [ CONT. , 0 ~ 240 min ] ( Default: 120 min [In steps of 10 minutes] )
[CONT.] means that the fan is always kept operating.
RENEW
Change fan operation. ( The fan motor operates according to the setting.)
Available setting values: [ON , OFF]
The setting is not stored in memory.
The built-in exhaust fan operates during printing and behaves according to the setting of the stop timer
after completion of printing.
SETUP INTERLOCK
Switch to the operation that is interlocked with the dryness fan setting.
Feeding/TakeUP
Set ON/OFF of AMF unit and the current when an error occurs.
UNIT SELECT
Switch ON/OFF of AMF unit feeding / take-up device.
Available setting values: [ON , OFF]
FeedCurrentLvl.
Set when error 42 is displayed while using AMF unit feeding device or take-up device.
Available setting values: [0 to 100 %]
Gradually increase the value so that the error is not displayed.
DRYNESS FEED
Set whether or not to perform feeding for media drying.
Available setting values: [ON, OFF]
With DRYNESS FEED set to ON, the printer feeds the media up to the location of the post-heater where
the media is dried.
After waiting for a period of time that has been set by the setup Function (DRYING TIME - DRAWend),
the printer performs the next printing (media cutting). No back feed is performed. (Printing will be started
at the position to which the media has been fed for media drying.)