Specifications

6-17
Invoking MACHINE SETUP functions
List of functions
This section describes briefly the machine setup functions and their setting values.
Name Function Refer to
DRY & EXHST.FAN
Make operation / interlock / independent settings of the Dryness fan and the
Outside /Built-in exhaust fan.
p. 6-20
Feeding/TakeUP Set ON/OFF of AMF unit and the current when an error occurs. p. 6-21
DRYNESS FEED Change the feed operation after printing. p. 6-21
CONFIRM. FEED
Set whether or not to perform feeding the media after test printing for
checking of the printing result.
p. 6-22
PRE-FEED METHOD
*1
*1. Available to set only when dedicated sublimation transfer ink is used.
Switch the pre-feed operation method.
p. 6-22
HEATER SETUP Change the temperature range of the post-heater that determines whether
the temperature is reached.
p. 6-22
MEDIA CUT Allocate [] key to direct cut key. p. 6-22
TIME SET Set the date and time on the printer. p. 6-23
UNIT SETUP Change the units of temperature, length and area to be used with the printer. p. 6-23
STAMP SETUP
Make settings for outputting the date and time and printing conditions after
printing.
p. 6-24
CART. PRIORITY
Set the cartridge status setting to be used first using the double cartridge
automatic switching function.
p. 3-49
Test Draw Arrange
You can set the deployment direction of the test pattern to be printed when
performing test printing repeatedly.
p. 6-25
MEDIA DETECT The media thickness detection is switched to Automatic or Manual. p. 6-11
MACHINE NAME
When the printer is connected through the USB 2.0 interface to a system to
which two or more machines are connected, set the identifier of the printer
to have the system recognize it.
p. 6-25
ENV. TEMP.
Set the operation when drawing was tried to start with the temperature of
the place where this machine has been installed being outside the range of
usable temperature.
p. 3-47
INFORMATION
Display various information.
The items in [INFORMATION] can be set individually by pressing the
[INFORMATION] key.
p. 6-26