Specifications

5-15
Troubles for which error messages are displayed
Warning messages
Warning messages will appear chiefly to warn of the conditions of heaters or ink cartridges.
Warning message Cause Remedy
Close a cover.
An open cover was detected. Check the front cover and maintenance
covers.
If the same error message appears
again even after closing all the covers,
contact your local distributor to call for
service.
∗∗ NO MEDIA ∗∗
No media was detected. Set media. (See 3-7)
!EXCHANGE BATTERY
The battery of RTC has run down. Contact your local distributor to call
for service.
L.1>
!Replace a WIPER
Time to replace the wiper in the cap-
ping station with a new one has come.
(The wiping count has reached the
specified value.)
Replace the wiper with a new one.
(Execute [ST.MAINTENANCE] -
[WIPER EXCHANGE].) (See 4-48)
L.1>
!Do TEST DRAW
The nozzle recovery cannot be
expected because the printer has been
left standing for a prolonged period of
time.
Perform test printing. If nozzle missing
is serious, (See 3-22) execute
[ST.MAINTENANCE] - [NOZZLE
WASH] for maintenance.(See 4-10)
Heater Power OFF
The power to the heaters is off. Turn on the power to the heaters. (See
3-15)
If the same error message appears
again even after turning on the power
to the heaters, contact your local dis-
tributor to call for service.
PRE PRT POST
BREAK ∗∗°C ∗∗°C
A heater is disconnected.
(This example shows that preheater is
disconnected.)
Contact your local distributor to call
for service.
PRE PRT POST
THERM ∗∗°C ∗∗°C
The thermistor of a heater is defective.
(This example shows that the ther-
mistor of preheater is defective.)
Contact your local distributor to call
for service.
∗Media can't be CUT∗
The heads are positioned too high to
permit media cutting.
Cut the media by manual operation.
(See 6-11)
L.∗>
INK Near END MBYK - - - -
Ink for one supply path has been nearly
used up.
Replace the cartridge for the supply
path corresponding to the indicated
color. (See 3-42)
Printing is permitted without replacing
the cartridge (until INK END is dis-
played). However, the printer returns
to local mode every completion of
printing one file.
R.∗>
INK Near END MBYK - - - -
L.∗>
INK END - - - - KYBM
Ink for one supply path has been com-
pletely used up.
Replace the cartridge for the supply
path corresponding to the indicated
color. (See 3-42)
L.∗>
CARTRIDGE - - - - KYBM
Ink cartridge for one supply path has a
problem.
Check the content of the warning by
displaying it using the guidance func-
tion.
Replace the cartridge for the supply
path corresponding to the indicated
color. (See 3-42)