Specifications

4 Daily Maintenance
4-56
Replacing the wiper [WIPER EXCHANGE]
The wiper is consumable.
When the display indicates that it is necessary to replace the wiper, immediately replace the wiper with a new
one. (Solvent wiper kit : SPA-0125)
STEPS:
1 Make sure that the printer is in LOCAL mode, and then press the [ST.MAINT] key.
[CARRIAGE OUT] is displayed.
2 Select [WIPER EXCHANGE] by pressing the [] key once and press the [ENTER] key.
The carriage will come out of the capping station.
3 Open the right maintenance cover, and remove the wiper.
Pull out the wiper by holding the projections at both ends.
Use the gloves that are supplied as an item of the cleaning kit to protect your hands from stains.
 Do not select [WIPER EXCHANGE] at any time other than when the wiper is to
be replaced.
Once it is selected, the number of wiper operations that is counted in the
printer will be reset.
 The wiper to be newly installed is available as an option.
Order it from your dealer or a sales office of MIMAKI.
 For cleaning, we recommend the use of the clean stick. If using cotton swab,
remaining lint of the cotton swab may cause printing failure.
L. ∗ >
width : ∗∗∗∗ mm
ST.MAINTENANCE
CARRIAGE OUT <ent>
Once
ST.MAINTENANCE
WIPER EXCHANGE <ent>