Specifications

4 Daily Maintenance
4-38
Cleaning interval while in stand-by mode [CLEANING]
This function is to be executed instead of TUBE WASH after the cleaning solution has been used up.
Set the cleaning type and the intervals at which cleaning operation is to be performed.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [ROUTINE SETUP] by pressing the [] key six times and press the [ENTER]
key.
3 Select [CLEANING] by pressing the [] key three times and press the [ENTER] key.
 This function does not operate when the error message relating to ink, such as
INK NEAR END or INK END, is displayed.
 While this function is being executed, the display indicates the progress of
cleaning and no key operation is available. (Refer to “If the printed pattern is
abnormal (Cleaning) (p.3-23)” )
 This function operates only when the printer is left with the display as shown
below:
L. ∗ >
width : ∗∗∗∗ mm
R. ∗ >
∗∗.∗∗ m
L. ∗ >
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
ROUTINE SETUP <ent>
6
times
Clean.worksAtTheTime
of the WashLiquidEND
ROUTINE SETUP
CLEANING <ent>
2
times