Specifications

4-37
Setting periodical operations in stand-by mode [ROUTINE SETUP]
Tube cleaning interval while in stand-by mode [TUBE WASH]
There may be a chance that ink tubes can be clogged with coagulated ink.
To avoid clogging, clean the ink tubes at regular intervals.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [ROUTINE SETUP] by pressing the [  ] key six times and press the [ENTER] key.
3 Select [TUBE WASH] by pressing the [] key twice and press the [ENTER] key.
4 Input the interval at which cleaning operation is to be performed periodically, using
the [] or [] key.
Input range: OFF, 1 to 168
Register the setting by pressing the [ENTER] key.
5 Press the [END] key several times.
The printer returns to LOCAL mode.
 To prevent clogging in the flushing BOX, this machine puts the cleaning solu-
tion into the flushing BOX with PUMP tube cleaning function.
Depending on the amount of ink put into the flushing BOX, PUMP tube cleaning
is automatically executed.
 The following display will appear if supply of cleaning liquid is required.
L. ∗ >
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
ROUTINE SETUP <ent>
6
times
1 time
WashingIntervalInThe
stand by is set up.
ROUTINE SETUP
TUBE WASH <ent>
ROUTINE SETUP
WASH INTERVAL = 1h
∗∗ Washing liquid ∗∗
L. ∗ >
width : ∗∗∗∗ mm