Specifications

3-21
Other notes
When cutting media
After drawing, if you wish to cut the media with scissors etc., be careful about the following point:
 If you cut the media with scissors etc., the media may drop into the ink tray and be blot-
ted. When cutting media, follow the procedures below:
1. Feed the printing part from the cut groove to the take-up
machine side manually.
2. Return the tension bar to the waiting position and cut the media
on the cut groove located on the dryness fan.

Cut it using scissors etc.
3. Cut the feeding side in the rear of the machine in the same way.

Return to the tension bar to the waiting position and cut it in front of
the Pre heater.
4. Release the clamp and remove the media remaining on the
platen surface.

The media remaining on the platen surface is blotted with ink in the ink
tray. When removing media, pay fully attention not to blot your hand.