Specifications

3 Printing
3-18
Effective Plotting Area
The printer has an area where printing is not permitted, for mechanical reasons.
This area is called “non-printing area”.
Margin
This function adjusts the right and left margins of the media.
Use this function when margines other than 25 mm, which is the standard margin, are required.
Dead spaces can be set on both in the right and the left respectively (-20 to 75 mm).
 The default value of dead spaces in the right and the left differs depending on the
media detection method or the media type to use.
Use the following value as reference:
<When printing on fabric>
Automatic media width detection: "71 mm" from media press
Manual media detection : "40 mm" from media edge surface
<When printing on paper>
Automatic media width detection: "49 mm" from media press
Manual media detection : "25 mm" from media edge surface
 You can change these dead spaces and effective drawing area. Set the margin with
“Margin” in the function mode.
Roll media
Media feeding
direction
0 mm
Left dead space Right dead space
Effective
printing area
150 mm