Specifications

3 Printing
3-4
Attaching/removing platen sheet metal
When using transfer paper for the media, attach the platen sheet metal.
When using fabric media, remove the platen sheet metal.
Attach the platen sheet metal
When using sublimation transfer paper, attach the platen sheet metal.
There are two types of platen sheet metal; platen sheet metal R with
projection and platen sheet metal L without projection.
1 Prepare the platen sheet metal R and attach it quietly with making projection in front.
Attach the platen sheet metal R on the right side of the machine.
Set the platen sheet metal R so that its projection enters into the hole of the platen sheet metal holder located in
the center of the machine.
2 Attach the platen sheet metal L.
Attach the platen sheet metal L aligning it with the left edge of the platen sheet metal R.
The platen sheet metal L has no projection. When attaching it, it does not matter either side is in front.
 There are two types of platen sheet metal; with or without projection.
When using it, set the platen sheet metal with projection on the right side of the
machine making the projection in front and set the one without projection on the left
side.
 When attaching/removing platen sheet metal, hold rectangular holes (on two positions)
on the platen sheet metal.
 Be careful when attaching/removing platen sheet metal so that it may not break off or
bend.
 Attach/remove the platen sheet metal with the power supply OFF.
 The platen sheet metal has projection and edged part. Care should be taken when han-
dling.
 When attaching, while holding rectangular holes on
two positions, attach the platen sheet metal R quietly
so that you may not break off or bend it.
Projection
Platen sheet metal R
Rectangular holes
Platen sheet metal L
Hole of platen sheet metal holder
Right edge of platen
sheet metal R
Right wall of ink tray
Status of platen
sheet metal R
whose projection
is set properly
Platen sheet metal R