Specifications

2-15
Operation to set function menus
SLEEP SET UP
Refer to the Chapter
4 of the JV5-320S
Operation Manual.
REFRESH REFRESHinter-
val
OFF, 1 to 168 h While the power switch is off, the
printer performs refreshing opera-
tion at fixed intervals to prevent ink
clogging or the like.
Set the interval (in hours) at which
refreshing operation that discharges
ink from the heads is to be per-
formed.
TUBE WASH WA SH I NTE R-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
pump tube cleaning operation is to
be performed.
CLEANING CLEAN. INTER-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
cleaning operation is to be per-
formed.
CLEAN. TYPE Normal, Soft, Hard Set a type of cleaning.
ROUTINE SETUP
Refer to the Chapter
4 of the JV5-320S
Operation Manual.
REFRESH REFRESHinter-
val
OFF, 1 to 168 h Set the interval (in hours) at which
refreshing operation is to be per-
formed.
TUBE WASH WA SH I NTE R-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
pump tube cleaning operation is to
be performed.
CLEANING CLEAN. INTER-
VA L
OFF, 1 to 168 h Set the interval (in hours) at which
cleaning operation is to be per-
formed.
CLEAN. TYPE Normal, Soft, Hard Set a type of cleaning.
Sub-INK WARNING OFF, 12 to 120 h Set the interval (in hours) at which
cleaning operation is to be per-
formed to prevent color change
because this machine has been left
and color material has settled.
WIPER LEVEL
Refer to the Chapter 4 of the JV5-320S Operation Manual.
10/10 to 1/10 The wipers are consumables. The
heads can get dirty easily in a dusty
atmosphere.
The heads cannot be cleaned ade-
quately with curled or worn wipers.
This printer gives the wiper replace-
ment warning earlier than standard
depending on the operating environ-
ment. (10/10 = Default)
HEAD SELECT
Refer to the Chapter 5 of the JV5-320S Operation Manual.
[1234]
[123–] , [–234]
[12––] , [–23–] , [––34]
[1–––] , [–2––] , [––3–] , [–––4]
Select the head(s) to be used for
printing.
Any of the combinations of heads
shown at left is available.
MEDIA RESIDUAL (Refer to P.6-13 in this manual.) ON, OFF Set ON/OFF of the media remaining
amount display function.
Input the media length (initial value
of remaining amount ) when the roll
media is detected.
BeforeMovingIt. (Refer to P.6-14 in this manual.) Use this function to lock the station
when the printer is to be transported.
Function name Sub function Setting value Function