Specifications

2 How to print on double side
2-14
8 Adjust misalignment of scan direction on both sides.
1. When the printer receives the data for back side printing, it prints Misalignment check line for scan direction
(See 2-7).
2. Check Misalignment check lines for scan direction on both sides are completely overlap. If misaligned, press
[] [] key and adjust the position.
Decrease the number to adjust the back side printing position to the right, and increase the number to adjust
to the left.
3. Press [ENTER] key to start printing on back side.
 After printing “Misalignment check line for scan direction”, the media stops
without being fed to LED light unit. Depending on media types, you cannot
check the misalignment visually since the front line cannot be seen from the
back.
In this case, measure the length from “Misalignment check line for scan direc-
tion” to the edge of media in advance, and input the difference with jog key.
 You can use this function even while printing on back side, with [][] key.
Use when misaligned while printing.
The adjustment value is valid only in one file.
No misalignment
(No need to adjust)
Front
Adjust to minus direction.
If 1 mm misaligned, press
[] key to adjust -1mm.
Misalignment check line for scan direction
Back
Adjust to plus direction.
If 1 mm misaligned, press
[] key to adjust +1mm.
23mm
Front
If the front line cannot be seen from the back: Input the difference (-2mm for the case below)
Back
25mm
Edge of media
Edge of media
BackPrint POS. COMP
+1.3mm