Specifications

2-11
Print image data
4 Turn over the media and set on the printer.
Be careful of followings.
For the detail of usual media setting, see JV5-320S Operation Manual.
1. Open the front cover and raise the clamp lever.
2. Insert media between the pinch roller and the platen.
3. Set the media so that the cuts on the cutting line become parallel to the line of the platen.
4. After detecting media, Set position check line (See 2-7) is automatically printed, and the lines are fed up
to the LED light unit.
Check the lines of both sides to check the media is set parallel to the image printed on the front side.
After checking, press [ENTER].
 Before printing on roll media, check the media is not slack on the back of the
printer.
If bowed, rewind the roll media manually to take up the slack. With a slack, it
may cause defective printing.
 When using take-up device, check the front is parallel to the back with the fol-
lowing way, then set the media to the take-up device. If media is set to the take-
up device before checking, setting the media again may be hard.
 If Set position check lines on both sides are not parallel, raise the clamp lever
and set the media again. The check line can be printed up to 6 times.
Media
Line of the platen
Cut
During the media set
COMPLETED :ent
Good: parallel
Front
Not good: not parallel
Set position check line
Back