Specifications

2 How to print on double side
2-10
2 Set the number of ink layers.
1. Press [] [] key, select [INK LAYERS], then press [ENTER] key.
3. Press [
] [] key, select the number of ink layers for printing on back side, then press [ENTER] key.
3 Set the re-detection interval of media.
When the printing media reaches the specified length, media is detected again to adjust the media misaligned
position by skewor others.
1. Press [
] [] key, select [MEDIA DETECT], then press [ENTER] key.
2. Press [
] [] key, and select the re-detection interval of media.
 While printing on back side, the printer follows the setting below. The settings
on [SETUP] function or on Raster Link Pro III are invalid.
 When [1] is set above, it may not print well such as unusual lines appear on
printed images.
DoubleSide Mode
INK LAYERS <ENT>
DoubleSide Mode
INK LAYERS : 2
1 to 9
DoubleSide Mode
MEDIA DETECT <ENT>
DoubleSide Mode
Detect INTVL :10000mm
OFF/10 to10000