Specifications

3-17
Setting the media on the printer
4 At the front, push the clamp lever up.
5 At the front, pull out the media.
From the front, taking both ends of the media by 2 people, pull out the media about 50cm longer than floor. (To
set the media straight, pull out the media long.)
6 At the back of the printer, close the covers on right and left sides of the roll shaft.
7 At the back, lift the tension-bar down to the stopper slowly to tighten the media.
8 At the back, push the clamp lever down.
Tension-bar (Grip this part)