Specifications

3 Printing
3-10
2 At the front, open right and left covers of heavy-duty take-up device, and take out the
roll shaft.
3 Remove heavy-duty roll holders on both sides of the shaft.
1.Loosen screws (1 each on the right and left) with supplied ratchet handle.
2.Remove the holders.
4 Put the roll shaft through a free paper core, and fix heavy-duty roll holders to the
core.
1.Slide the paper core to the center of the roll shaft.
2.Push both sides of the heavy-duty roll holders into the core, and tighten screws with supplied ratchet handle
to fix.
Cover
1
2
2
1
Ratchet handle
Roll holder
Ratchet handle