Specifications

1 Safety Precautions
1-22
Notes on USB 2.0 Interface
When two or more JV5 printers are connected to one personal computer
When two or more JV5 printers are connected to one personal computer, the personal computer may not
recognize all the JV5 printers normally.
Reconnect the unrecognized JV5 printer to another USB port, if available, and check to see if it is recog-
nized. If the JV5 printer is not recognized even through the newly connected USB port, use USB 2.0
repeater cables available on the market.
Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is con-
nected to the same personal computer that a JV5 printer is connected to, the USB device may not be recog-
nized.
When a JV5 printer is connected to the personal computer to which an externally installed USB hard disk
drive is connected, the data output speed to the JV5 printer may drop. That can cause the head unit to stop
temporarily at the right or left end during printing.
Removing USB memory
If a USB memory module is inserted in the personal computer to which a JV5 printer is connected, click
“Stop” in the “Safely Remove Hardware” window by following the instructions given there first and then
remove the module. Leaving a USB memory module inserted can cause [ERROR 10 COMMAND
ERROR].
Copy the data onto the hard disk before outputting it for printing.
 Your RIP must be compatible with USB 2.0.
USB 2.0 repeater cable