Specifications

6-15
Invoking MAINTENANCE functions
Setting a maintenance function
Take the following steps on the operation panel to execute a maintenance function.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key once.
2 Select a maintenance function and make setting.
Operation procedure with the [ST.MAINT] key (ST.MAINTENANCE)
1 Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key once.
2 Press the [ST.MAINT] key.
As [ST.MAINTENANCE] is displayed, perform each maintenance operation.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ST.MAINTENANCE
CARRIAGE OUT <ent>