Specifications

6-3
Invoking SET UP functions
Invoking SET UP functions
Registering printing conditions in a lump (type registration)
FUNCTION mode provides 17 setup functions. (In the case of usage, it is 18 items about dedicated subli-
mation transfer ink (Sb51).)
The setting value of each of the 16 functions other than SETUP RESET can be registered as any of the fol-
lowing four types. (In the case of usage, it is 17 items about dedicated sublimation transfer ink (Sb51).)
If the types are registered for different kinds of media, respectively, printing conditions can be easily
changed when the media is replaced with another kind of media.
Example of type registration
List of functions
This section describes briefly the setup functions and their setting values.
When solvent ink is used.
Type 1 For Tarpaulin 1
Type 2 For Tarpaulin 2
Type 3 FF (Flexible Face)
Type 4 PVC
Name Function Refer to
MEDIA COMP. Corrects the feed rate of media p. 6-5
MediaFeed SETUP Set particulars related to media feed. p. 6-5
HEATER Sets heater conditions p. 6-5
PRINT MODE Sets a print quality level and printing direction p. 6-6
INK LAYERS Sets the number of layers in which ink is to be applied p. 6-8
DRYING TIME Sets the time to wait for ink drying p. 6-8
AUTO CUT Cuts the media automatically after printing p. 6-9
PRE-FEED Feeds the media back and forth before printing p. 6-9
MARGIN Sets a non-printing area along the right and left edges of the media p. 6-9
COLOR PATTERN
Prints a color pattern on the right edge (also on the left edge while using
sublimation transfer ink Sb51) of the media to check nozzle missing
p. 6-10
REFRESH Refreshes the print heads during printing p. 6-11
VACUUM Sets the absorbability of the media. p. 6-11
PRIORITY Sets the priority of settings (host / panel) p. 6-11
AUTO CLEANING Cleans the print heads automatically every completion of printing p. 6-12
Print. MAINTE
*1
*1. Only when dedicated sublimation transfer ink Sb51 is used, [Print. MAINTE.] can be set.
Automatically cleans or wipes the heads regularly while printing. p. 6-12
HEAD GAP Sets the head gap (height from the media to the nozzle plane of the heads). p. 6-12
MEDIA DETECT Sets the method for detecting the media p. 6-12
SETUP RESET
*2
*2. Each item excluding [SETUP RESET] can be registered on the type.
Resets the setting values to the default values
p. 6-13