Specifications

4 Daily Maintenance
4-22
PUMP tube cleaning
Wash the two ink suction pumps of the four pumps installed in this printer.
By driving the cleaning liquid suction pump, wash the ink caps, ink exhaust passages, and the inside of the
tubes of the ink suction pumps.
Washing will not be started if the cleaning liquid has not been supplied or if a warning is generated for the
cleaning liquid cartridge or waste ink tank.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then press the [ST.MAINT] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [PUMP TUBE WASH] by pressing the [  ] key five times and press the [ENTER] key.
 Into the cleaning liquid cartridge slot, do not insert any cartridge other than the
cleaning solution cartridge.
 Before executing the [PUMP TUBE WASH] function, the tubes must be filled
with the cleaning solution. For how to fill the tubes with the cleaning solution,
refer to following page.
(Refer to “Before executing the [PUMP TUBE WASH] (p.4-19)” )
 If there is a problem with the waste ink tank, the display will show either of the
following messages.
Follow the displayed instructions to restore the normal conditions.
 The following display will appear if supply of cleaning liquid is required.
No waste ink tank,
or a tank is FULL.
<ENT>keyHIT is after
theTANK set or exchg
Replace a
waste ink tank.
<ENT>keyHIT is after
the TANK exchange.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ST.MAINTENANCE
CARRIAGE OUT <ent>
5
times
ST.MAINTENANCE
PUMP TUBE WASH <ent>
Fill with the maint.
washing liquid.
∗ ∗ ∗ ∗ ∗ ERROR 30 ∗ ∗ ∗ ∗ ∗
OPERATION ERROR