Specifications

3-59
Printing an image
Cutting the media after completion of printing
After completion of printing, cut the media at any desired position without using the [AUTO CUT] func-
tion.
STEPS:
1 Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2 Press a JOG key the appropriate number of times until the display turns as shown
below, and then press the [FUNCTION] key.
The position to cut is decided by JOG key.
Any of the JOG keys can be used.
 Before cutting media, lift two tension-bars up and fix with the locks.
If not lifting the tension-bars, the cutter does not work.
 When cutting with your cutter or scissors instead of the cutter of this machine,
be sure to lift the tension-bars up. Since the bars hang by media, for safety, do
not cut media without lifting tension-bars up.
 Do not turn off the main power switch at the rear of the printer even after com-
pletion of printing. If the main power switch is turned off, nozzles may be
clogged.
 When the current head height is 4.0 mm or more, media cutting cannot be per-
formed.
Head height is equal to [head gap] + [thickness of media]. (See 3-5)
 With [AUTO CUT] function turned on, the printer automatically cuts the media
every completion of printing each image. (Refer to “AUTO CUT (p.6-9)” )
 If the media is not cut, following message displays.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
MEDIA CUT
<ENT>
ORIGIN SET UP
0.0 −−−−
*Media can’t be CUT*
*****ERROR 30*****
OPERATION ERROR
When head height is more than 4.1mm
Tension-bar of take-up side is not at lock position
Take shelter
the tension-bar.