Specifications

3-13
Setting the media on the printer
11Hold the medium with the media press gently.
12Set a free paper tube on the take-up device.
13Adjust the level adjusters of the take-up device so that the bottom of each of them
rests on the floor and secure them by tightening the thumb screws.
 Take care not to cut your finger with the media press.
 Make setting so that the suction hole at the right end of the platen is covered
with the right end of the madia, and adjust the position of the roll holder.
 When using a thick media, remove the media press from the media before
printing.
Rightmost pinch roller
Suction hole
Media press
Media end