Specifications

1-21
Basic specifications
To use Eco-HS1 ink with a good image quality
 Head gap (the length between media and head nozzle) is recommended to set less than 1.5mm.
If printing with over 2.0mm setting, the image quality is not guaranteed for ink-splash.
 Recommended heater temperature for PVC sheet are PRE/PRINT 40 degree or below, AFTER 50
degree or below.
 Please set difference of temperature of heater temperature and the environmental temperature to less
than 30 degrees.
When difference of temperature was used in more than 30 degrees , the dew condensation of the ink
solvent ingredient is generated on the head surface, and we cannot guarantee a image.
 Please do not remove the cartridge until ink was exhausted, there is the possibility that the ink may leak.
When removing an ink cartridge from a printer, please do not turn an ink outlet upside down.
There is possibility that ink hangs from an ink outlet.
To use Eco-PA1 ink with a good image quality
 Head gap (the length between media and head nozzle) is recommended to set less than 2.0mm.
If printing with over 2.0mm setting, the image quality is not guaranteed for printing misalignment.
 If printing under a high temperature (more than 30°C, set the reflesh level to "3".
 Print within the available temperature of this machine (20°C to 35°C).
If printing under the temperature out of the range, the image quality is not guaranteed for spattering of
ink droplet.
 When media is jammed, remove the jammed media immediately and execute cleaning.
If leaving the machine for some time with the media jammed, the nozzle may be difficult to recover, or
may not recover.
 To avoid media jam, when executing unattended operation, take care of the media such as using a
cockle-resistant media, or setting a media without a lift or misalignment.
 For the cockled media, the image may be misaligned at bi-direction printing, and it may worsen the
image quality. In this case, printing by uni-direction is recommended.