Specifications

6-3
Invoking SET UP functions
Settings of the setup functions
The operation described below on the operation panel is required to execute the setup functions.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [SET UP] using the
[FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select an appropriate one of Type 1 to Type 4 by means of [] or [], and press the
[ENTER] key.
Set the printing conditions.
3 Select a setup function and make setting.
REFRESH Refreshes the print heads during printing p. 6-9
VACUUM Sets the absorbability of the media. p. 6-9
PRIORITY Sets the priority of settings (host / panel) p. 6-9
AUTO CLEANING Cleans the print heads automatically every completion of printing p. 6-10
Print. MAINTE
*1
Automatically cleans or wipes the heads regularly while printing. p. 6-10
HEAD GAP Sets the head gap (height from the media to the nozzle plane of the heads). p. 6-10
MEDIA DETECT Sets the method for detecting the media p. 6-11
SETUP RESET
*2
Resets the setting values to the default values p. 6-11
*1. Only when dedicated sublimation transfer ink is used, [Print. MAINTE.] can be set.
*2. Each item excluding [SETUP RESET] can be registered on the type.
Name Function Refer to
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
SET UP <ENT>
SET UP
SELECT : TYPE 1
SET UP
SELECT : TYPE 2