Specifications

5 In Case of Trouble
5-6
If nozzles are still clogged even after head cleaning
Execute the following two functions if blocked nozzles are not unclogged even by executing HEAD
CLEANING (Refer to ?If the printed pattern is abnormal (Cleaning) (p.3-29)? ) and NOZZLE
WA SH (Refer to ?Cleaning the nozzle [NOZZLE WASH] (p.4-10)? ) .
[DISCHARGE&WASH]
Discharge ink from the heads, dampers and ink tubes, and washe them.
STEPS:
1 Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key once.
2 Select [HD.MAINTENANCE] by pressing the [] key twice and press the [ENTER] key.
3 Select [DISCHARGE&WASH] by pressing the [] key once and press the [ENTER]
key.
FILL UP INK
Supplies ink to correct nozzle clogging.
(Refer to ?If nozzles cannot be unclogged [FILL UP INK] (p.3-31)? )
DISCHARGE&WASH
Discharges ink from the heads, dampers and ink tubes, and washes them with an clean-
ing solution cartridge (option).
 If there is a problem with the waste ink tank, the display will show either of the
following messages.
Follow the displayed instructions to restore the normal conditions.
No waste ink tank,
or a tank is FULL.
<ENT>keyHIT is after
theTANK set or exchg
Replace a
waste ink tank.
<ENT>keyHIT is after
the TANK exchange.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
HD.MAINTENANCE <ent>
Twice
Once
HD.MAINTENANCE
DISCHARGE&WASH <ent>
HD.MAINTENANCE
FILL UP INK <ent>