Specifications

4-35
Setting periodical operations in stand-by mode [ROUTINE SETUP]
3 Press the [ENTER] key.
Once [SCAN COUNT] is displayed, press the [ENTER] key.
4 Input the value of SCAN COUNT using the [] or [] key.
Register the setting by pressing the [ENTER] key.
5 Press the [] key to go to the lower level of hierarchy and input the value of
TEMP.difference.
Input a value of temperature difference using the [] or [] key, and register the setting by pressing the
[ENTER] key.
6 Press the [END] key several times.
The printer returns to LOCAL mode.
 The initial value of SCAN COUNT is 0 (no wipe). Change the setting value
according to the conditions of use.
Set SCAN COUNT to about 30 to 50 when the heater temperature is set to 50 °C
or above or ink is to be applied in two or more layers.
 The ROUTINE WIPING function is activated when the setting temperature of the
print heater is higher than the ambient temperature and the difference is larger
than the value of “TEMP.difference”.
Wiping in the
drawing is set up.
ROUTINE SETUP
ROUTINE WIPING <ent>
The interval of
wiping is set up.
ROUTINE WIPING
SCAN COUNT <ent>
0 - 9990cnt (0 = OFF)
ROUTINE WIPING
SCAN COUNT = 50
1 - 60 °C
ROUTINE WIPING
TEMP.DIFF. = 20 °C
Set up a difference
in Temperature.
ROUTINE WIPING
TEMP.difference <ent>
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm