Specifications

3-41
Printing an image
Cutting the media after completion of printing
After completion of printing, cut the media at any desired position without using the [AUTO CUT] func-
tion.
STEPS:
1 Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2 Press a JOG key the appropriate number of times until the display turns as shown
below, and then press the [FUNCTION] key.
The position to cut is decided by JOG key.
Any of the JOG keys can be used.
3 Press the [ENTER] key.
The printer cuts the media.
4 The printer returns to LOCAL mode.
The printer restores the same status as before entering printing mode.
 Do not turn off the main power switch at the rear of the printer even after com-
pletion of printing. If the main power switch is turned off, nozzles may be
clogged.
 When the current head height is 4.0 mm or more, media cutting cannot be per-
formed. (When the ink used is other than sublimation transfer ink)
Head height is equal to [head gap] + [thickness of media]. (See 3-5)
 With [AUTO CUT] function turned on, the printer automatically cuts the media
every completion of printing each image. (Refer to ?AUTO CUT (p.6-8)? )
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
MEDIA CUT
<ENT>
ORIGIN SET UP
0.0 −−−−
MEDIA CUT
<ENT>
MEDIA CUTTING
PLEASE WAIT
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm