Specifications

3 Printing
3-34
3 By judging from the output pattern, enter a correction value using the [] or [] key.
4 Press the [ENTER] key to register the correction value.
Repeat steps 2 to 4 until normal printing result is obtained.
5 Press the [END] key several times to return to LOCAL mode.
 A change of the value of [VALUE] by 6 will move the band by about 0.01 mm.
Remember this when determining the correction value.
Correction value:
-255 ~ 255
About 0.01mm changes
with 6.
[1]MEDIA COMP.
VALUE = 0
Correction value is too large
OverlapClearance
Correction value is too small
About 0.01mm changes
with 6.
[1]MEDIA COMP.
VALUE = 0
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm