Specifications

3-5
3
Convenient use
Setting media compensation
Correct the feeding rate of media after the type of media is replaced or the temperature of Heater is
changed.
If the correction value is not appropriate, stripes may appear on the print, thus resulting in a poor print.
Setting media compensation
Print the compensation pattern then correct the feeding rate of media.
1
Set a media.( P.2-6)
2
Press the key in the local
mode.
3
Press the key.
4
Select the type (1-4) by pressing the
keys.
• When any heater temperature is changed, first make sure that the [ CONSTANT ] lamps light
and the preset temperatures have been reached, and then start correction.
• On completion of [MEDIA COMP.] during use of a roll media, the media returns to the printing
origin. Then the roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by hand; a loose roll media can result in an
inferior image quality.
• When printing is to be performed while using the take-up device, set the media first and then
perform [MEDIA COMP.]. (Except Type B)
• Print two bands as the compensation pattern.
• Adjust so that an even color density is obtained around the boundary between the two bands.
Second band
First band
Media advance direction
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1