Specifications
2-28
About warning message display of performing spot color maintenance
When silver ink of ES3 ink is used and when ink has been left for two days and
more without being used, to prevent color heterogeneity due to settling down of
pigment, the message on the right is displayed on the screen.
Silver ink change their colors if they have been left for about two days.
If the warning message is displayed, perform special color mainte-
nance by following the procedures below:
1
If the warning message is displayed, press the key.
• If you do not wish to perform spot color maintenance, press the
key to cancel the operation.
2
Press the key.
3
Remove the ink cartridge of the displayed color on the screen.
• The lamp located above the cartridge lights to inform you of the ink cartridge to be
removed.
• After the ink cartridge is removed, ink discharging starts.
• When discharging is completed, the screen on the
right is displayed.
4
Slowly shake the removed ink cartridge more than twenty times
right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover
the A part of the upper surface of the cartridge and the B part of the bottom surface of the
cartridge with paper towels. Then, shake it more than twenty times right and left so that ink
flows inside the cartridge.
• If you shake it too strong, the pack inside may be damaged and it may cause
ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten
enough. Tilt the cartridge until it becomes vertical.
PERFORM SPOT COLOR
MA I NT ENANCE ? < ENT >
COLOR : S I L VER
REMOVE : I NK CARTR I DGE
_S_W____
*DISCHARGE*
03 : 00
SHAKE I NK CARTR I DGE
:
e
nt
A part
(the place to stick a
needle)
B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
Repeat
this
A part