Specifications

2-15
Setting medias
2
Basic Operations
7
Press the key.
8
Press the key to select “LEAF” .
9
The media detection is started.
( 1 ) The media width is detected.
( 2 ) The media is fed then the rear end of media is detected.
( 3 ) It returns to the local mode when the detection is completed.
Notes when using media press
• Do not set media at the position which the media press touches the side plate on the right.
As media may tilt and be lifted, it could break the head.
•
If a media is misaligned to the right more than fixed position, a
warning is displayed. Set the media again.
MED I A SE L ECT
ROL L < > L EAF
DETECT I NG MED I A NOW
PLEASE WA I T
***** ERROR 50 *****
MEDIA SET POSITION R
Media
Media Press
Side plate
on the right
Media press position:27 to 38 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
• Do not locate the suction hole on the platen between
the media and the media press. (It may stain the
media.)
Suction
hole