Specifications

2-9
Setting medias
2
Basic Operations
3
Move the roll holder to the roll setting position.
• Check the roll stopper is not caught between the roll stopper arm and this machine.
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll
media on the let roll holder.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
6
Loosen the screw of the right side roll
holder then insert the holder into the
core of the roll media.
7
Raise the clamp lever in the front of
this machine.
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Roll holder
Basis
Setting position
of 3inch tube
Setting position
of 2inch tube
Roll Holder Side
(The back of this machine)
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Set the base position
of roll holder within
this range.
• There are two types of the internal diameter of
the roll media paper tube: 2 inch and 3 inch.
Clamp lever