Specifications

2-7
Setting medias
2
Basic Operations
4
Keeping the height adjusting lever held
at the aforementioned position, tighten
the two screws.
• Be sure to fasten the screws, pressing the height-
adjusting lever, otherwise the head can not be
secured at the correct position.
• Fasten the screws securely.
5
Return the carriage to the station posi-
tion.
For the adjusting lever and the range
Range
Height adjusting
lever
Head height Switching area
L range
(General printing)
Thin : light-weight
2mm
(The set position at
shipping)
Switch by user
Contact to our sales
office for switching
L <-> H by field per-
son.
Thick : heavy-weight 3mm
H range
(Transfer type
printing)
Thin : light-weight 4mm
Thick : heavy-weight 5mm
• Set the lever to "Thick" when a thicker media such as a tarpaulin or FF is used.
• Set the lever to the lower stage (Thick) if dust is likely to gather in the head or the head is likely
to rub on the media to leave ink on it.
• If solvent ink is selected, do not use with H range. It adversely affects the image quality.
• When using the media of 1mm thickness or below and SS21 ink, be sure to set the head
height to “Thin”.
If using with the head height “Thick”, as the head gap (between the media and the height of
head nozzle surface) can be too large and ink drops may be splashed, the image quality can-
not be assured.
• When the ink is changed from dye ink to other aqueous ink, or on the contrary, after the
machine is installed, the adjustment is required for the head initial height (H/L range). Consult
with our sales office about it.