Specifications

1-15

Before Use

Media

Useable media sizes and notes for handling are described.

Usable sizes of media

Caution in handling of medias

Pay attention to the followings for handling of medias.

Model JV33-130 JV33-160

Type of Recommended media Tarpaulin/ FF(Flexible Face)/ Weatherproof PVC

Maximum width 1371mm 1620mm

Minimum width 210mm 210mm

Maximum printing width 1361mm 1610mm

Roll media

Thickness 1.0mm or less

Roll outside diameter 180mm or less

Roll weight 25kg or less

Roll inside diameter 3 or 2 inches

Side printed Side facing outward

Roll end treatment

The roll end is gently fixed to the core with weak-adhesive

tape or weak glue for easy removal.

• Use media recommended by MIMAKI to ensure reliable, high-quality printing.

Set the heater temperature to meet the characteristics of the media.

• Set the temperature of the Pre-heater, Print heater and Post-heater according to the

type and characteristics of the media used.

Automatic temperature setting can be made on the operation panel by setting the profile on

the dedicated RIP. For setting on the RIP, refer to the instruction manual for your RIP.

• Pay attention to the expansion and contraction of the media.

Do not use media immediately after unpacking. The media can be affected by the room tem-

perature and humidity, and thus it may expand and contract.

The media have to be left in the atmosphere in which they are to be used for 30 minutes or

more after unpacked.

• Do not use curled media.

This may result in paper jamming.

If a regular-sized coated sheet of media is rolled and stored, the coated side has to face out-

side.