Specifications

4-36
Print the media remaining amount
You can print the current media remaining amount.
1
In the local mode,
press the keys.
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by
pressing the keys.
• Select the carriage and media, moving the
point with the keys.
• When not changing the origin, proceed to
the Step 3 without pressing
, , and key.
• When pressing key here, the ori-
gin will be changed and it will return to the
local mode.
3
Press the key.
• When pressing , , and
key, the screen will return to the Step 2
screen.
• When pressing key, it will return to the local mode.
4
Press the key.
• Start printing of the media remaining amount.
• When the printing completes, it will return to the local mode.
• Set [MEDIA RESIDUAL] to “ON”. ( P.4-35)
• When changing the media, it is recommended to print the remaining amount to the currently
used media. If you print the media remaining amount in advance, for using the changed
media, you can enter the correct value in the screen for entering media remaining amount
after detecting the media ( P.2-12).
• When printing after changing the origin, the origin set here will be valid when printing data sub-
sequently.
OR I G I N SETUP
0.0 ----
OR I G I N SETUP
0.0 0.0
Origin
(Length)
Origin
(Width)
MED I A RES I DUAL DRAW
<ENT>