Specifications

4-35
Other maintenance functions
4
Routine Maintenance
Setting the media remaining display
Set the media remaining amount display.
1
Select [MEDIA RESIDUAL] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [MEDIA RESIDUAL] by pressing the keys.
(4) Press the key.
2
Select ON/OFF by pressing the
keys.
3
Press the key.
4
Press the key several times to end.
When the media remaining
amount display is turned to
"ON"
The media remaining amount is displayed in the remote mode.
(The print length is displayed when a leaf media is used.)
When the media remaining
amount display is turned to
"OFF"
The media remaining amount is not displayed in the remote mode.
• The media feed during printing or with any of the JOG keys is reflected on media remaining
amount.
• Input the media length (initial value of remaining amount) when the roll media is detected.
• The setting performed in this section is not effective unless the media detection is performed
after the setting.
MED I A RES I DUAL
SETUP : O FF
MA I NT ENANCE
MED I A RES I DUAL < e n t >