Specifications

4-19
When Nozzle clogged after cleaning
4
Routine Maintenance
DISCHARGE & WASH
Discharge ink from the heads, dampers and ink tubes, and then wash them.
1
Select [HD.MAINTENANCE] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [HD.MAINTENANCE] by pressing the keys.
(4) Press the key.
2
Select [DISCHARGE&WASH] by press-
ing the keys.
3
Press the key.
4
Remove the ink cartridge.
• The ink left in the head or tube is discharged to the
waste ink tank.
• The display on the right is displayed after dis-
charging.
5
Set the cleaning solution cartridge to
the ink station.
• Absorbing of the cleaning solution is started.
• The display on the right is displayed after absorb-
ing.
• To use this function, the dedicated cleaning solution ( P.4-2"Notes on cleaning solution") is
required. In addition, before performing the work, check whether ink to be filled again remains
or not.
• When the following messages are indicated, check the waste ink tank, and then operate it,
referring to P.4-42 "If Waste ink tank confirming message is displayed" according to the situa-
tion.
Con f i rm a was t e tank
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange : e nt
HD . MA I NTENANCE
D I SCHARGE&WASH < e n t >
Remo ve : I nkCa r t r i dges
MMCC YYKK
*DISCHARGE*
00: 00
Se t :Wash i ngCa r t r i dge
1234 5678
*ABSOPRPTION*
00: 00
Remo ve : Ca r t r i dges
1234 5678