Specifications

Precautions in Maintenance
1-3
 Do not tilt the printer with the ink cartridges filled with ink. Doing so can give rise to leakage of ink.
In principle, the following procedures should be taken in prior to the transportation and the
transportation should be conducted using exclusive packaging material.
1. Remove the ink from the tube with MAINTENANCE in [HD.MAINTENANCE]-
[DISCHARGE&WASH] or [#ADJUST] - [HEAD WASH].
2. Remove the cleaner from the tube with MAINTENANCE in [HD.MAINTENANCE] -
[MaintWashLiquid] (if this action is not performed in Step 1.)
3. Detach the waste ink tank.
4. Fix the head with the head stopper. (As for the detail, see Setup Guide)
 If the main unit is removed from the legs and placed directly on the floor, be careful of the following
points.
• Unplug the take-up unit power cord.
• Remove the ink waste tank and the fitting bracket.
(Plug the tube up with a cloth to prevent ink from spilling over.)
1-1-2. Preliminary checks
Before starting work, make sure that the following conditions are all met.
 The following conditions for the power supply system are all met:
• The power supply voltage must be within the specification limits.
• The printer must be grounded properly.
• The power cable must be free from damage, broken wire, etc. Many cables must not be
connected to one outlet.
• Connected to an electrical outlet with a removable plug in cases where smoke or flame has been
emitted from the socket.
 Make sure that the printer is not located under any of the following conditions:
• In a place where the printer is exposed to direct sunlight.
• On an inclined surface.
• In an environment of too high or low temperature, or too high or low humidity, or in a place
where temperature or humidity varies significantly.
• In a place where vibration occurs.
• In a place where the printer is exposed to direct air flow from an air conditioner or the like.
• Around a place where flame is used.
• In a dusty atmosphere.
• Around a place where strong electromagnetic waves are generated.
 The media (sheets) to be used must conform to the specifications.