Specifications

Functions

2-39

System Parameter Input Mode

Starts the device in system parameter input state of #PARAMETER function.

This function is for initializing parameters when starting of device is disabled to start because of

parameter hash error and so on.

Starting method: Starts with pressing [] + [] (Or starts with pressing

[ENTER]

[END]

2-2-4. PARAMETER Function

PARAMETER function is a function to confirm and set parameters in the device.

Note: While accessing F-ROM and HEAD.EEPROM, display [F-ROM WRITING] and light up BUSY LED (red).

No.1~6: Default selection is allowed

No.7~14:Selection is allowed only at the maintenance open

No. Item Stored place Notice

1 SYSTEM PARAM. F-ROM sector 2

2 MAINTE PARAM. F-ROM sector 2

3 CUSTOM PARAM. F-ROM sector 2

4 RUNNING PARAM. F-ROM sector 1 /Backup SRAM

5 EXCHANGE PARAM. F-ROM sector 2

6 INKSYSTEM PARAM F-ROM sector 2

7 INKinfor.PARAM. F-ROM sector 2,8,9

8 INKSEQUENCEpara F-ROM sector 2,8,9

9 INKTYPE PARAM. F-ROM sector 2,8,9

10 HEADunit PARAM. F-ROM sector 1 /Backup SRAMHEAD.EEPROM

11 SERVO PARAMETER F-ROM sector 2

12 TEST PARAMETER F-ROM sector 2

13 CORRECT PARAM. F-ROM sector 2

14 ADJUST PARAM. F-ROM sector 2