Specifications

Functions
2-21
HEAD WASH
Cleaning head, damper and tube.
*1 As an IC chip is not placed in a washing solution cartridge, it is recognized that IC chip read error means normal
As it is non- filling state after the completion of cleaning, the Initial Filling (p.2-19) or filling of
corresponding head is required.
<Head wash operation sequence>
No. Item Operation content Notice
1 Preparation Confirm the change of ink set.
During the initial filling after cleaning the head, select "Yes" if you changed the ink set.
(The ink set cannot be changed except when the device is first shipped, because the coupler
needs to be changed)
2 Discharging of ink 1. Taking out cartridges (all slots). (Cartridge sensor monitoring)
2. Discharging ink (Ink suction motor driving)
Execute after the confirmation display when a waste ink tank warning occurs.
3 Cleaning 1. Inserting washing solution cartridges (all slots). (Cartridge sensor monitoring*
1
)
2. Cleaning inside of tube (Opening cartridge valve, ink suction motor driving)
3. Head vibrating operation (Y-axis motor) is executed
4 Discharging of
washing solution
1. Taking out cleaning cartridges (all slots). (Cartridge sensor monitoring)
2. Discharging washing solution (ink suction pump motor driving)
5 Repeating 3 ~ 4 are executed again.
6 Wiper Cleaning 1. Cap OFF
2. Wiper ON (after moving the carriage to the maintenance position)
Waiting for wiper cleaning end
(
[ENTER]
pressing to start the following No.)
7 Operation
selection
Press one of a key below to select an operation.
[] : Transit to No. 10 (END)
[] : Transit to No. 8 (CONTINUE)
[] : Transit to No. 3 (Re-WASH)
8 Filling of
transportation
liquid
1. Insert transportation liquid cartridge (all slots). (Cartridge sensor monitoring)
2. Fill head, damper and tube with transportation liquid
(Cartridge valve OPEN, Ink suction pump motor driving).
9 Discharging of
transportation
liquid
1. Taking out of transportation liquid cartridges (all slots). (Cartridge sensor monitoring)
2. Discharge transportation liquid.(with leaving appropriate amount)
(Cartridge valve OPEN, Ink suction pump motor driving)
10 Operation
selection
Press one of a key below to select an operation.
[] : End of head cleaning(END)
[] : Transit to No. 11 (DISCHARGE) (Maintenance washing solution discharge)
11 Maintenance
washing solution
discharge
1. Taking out the maintenance washing solution cartridge.
(maintenance washing solution slot)
2. Discharging maintenance washing solution.(pump motor driving)
12 Operation
selection
Press one of a key below to select an operation.
[] : End of head cleaning (END)
[] : Transit to No. 13 (FillUP) (Transportation liquid suction and discharge)
13 Transportation
liquid suction and
discharge
1. Inserting transportation liquid cartridge. (maintenance washing solution slot)
2. Transportation liquid suction (pump motor driving)
3. Taking out of transportation liquid cartridges. (maintenance washing solution slot)
4. Discharging transportation liquid (pump motor driving)