Specifications

Operation Principle
2-3
2-1-3. Set Up
Machine Configuration
The following required resources are checked.
2-1-4. Media Detection
Media width and media thickness are detected.
<Model determination>
No. Item Content
1 HDC connection
determination
When configuration of HDC is not completed, a HDC error (ERROR09) is displayed and the
system is brought to down.
2 Head connection
determination
An effective head connection is determined.
3 Head memory check Determines the head connection.
4 SDRAM check If size of SDRAM is 0, ERROR203 (SD-RAM size) is displayed and the system is brought to
down.
<Required SDRAM size>
128 MB
<Media detection operation sequence>
No. Item Content Notice
1 Media right end
detection
After moving the carriage to the media detection position, media right
end is detected. (media sensor)
Up the lever to stop the
detection.
2 Media left end detection 1. After moving the carriage, media left end is detected.
(media sensor)
2. After measuring the distance between the left end and the right
end, media width is calculated (linear encoder)
* During carriage moving of the media width detection, the
linear encoder is tested.
If an error is detected, drawing is disabled. (ERROR8)
[ERROR8 detailed information]
DIRECTION: ± of counter of the linear encoder is wrong
COUNT: Count number of the linear encoder is error
SENSOR: Count failure
* When the media width can not be detected, ERROR50.
(Up the lever to release)
Returning the carriage to the Y-original point and cap ON.
* Distance accuracy adjusting is automatically executed in the media
detection.
Up the lever to stop the
detection.
3 Media length inputting When “MEDIA RESIDUAL” of the MAINTENANCE function is set
to ON and media return end detection failed, input media length.
Set value: 1 ~ 500m (unit:1m)