Specifications

Color Inkjet Printer JV33-130/160
4-10
4-2-2. Warning messages and corrective measures
<Warning messages and corrective measures >
Display Cause
Remedy (instruction & maintenance manual)
Descriptions in the manual
(for reference)
Remedy
Close a cover.
An open cover was detected. Check the front cover and maintenance
covers.
If the same error message appears
again even after closing all the covers,
contact your local distributor to call for
service.
1. Make sure that the cover sensor works
properly with [#TEST]- [SENSOR
TEST].
2. Make sure that the toggle pushes the
lever of the cover sensor firmly.
3. Make sure that the cables are con-
nected properly.
4. Replace the cover sensor with a new
one.
<LOCAL.1> [#01]
** NO MEDIA **
No media was detected. Set media. 1. Check that the paper sensor R works
properly with [#TEST] - [SENSOR
TEST].
2. Make sure that connection of the
cables is correct.
3. Replace the paper sensor R with a new
one.
!EXCHANGE BAT-
TERY
The battery of RTC has run
down.
Contact your local distributor to call
for service.
1. Replace the battery with a new one
having the same model number.
<LOCAL.1> [#01]
!Replace a WIPER
Time to replace the wiper in
the capping station with a new
one has come.
(The wiping count has reached
the specified value.)
Replace the wiper with a new one.
* Execute [ST.MAINTENANCE] -
[WIPER EXCHANGE].
1. Make sure that wiper replacement is
conducted with [MAINTENANCE] -
[ST.MAINTENANCE].
<LOCAL.1> [#01]
!Do TEST DRAW
The nozzle recovery cannot be
expected because the printer
has been left standing for a
prolonged period of time.
Perform TEST DRAW, and check for
omitted nozzles.
If nozzles are omitted, perform clean-
ing. If nozzle missing is serious, exe-
cute [ST.MAINTENANCE] -
[NOZZLE WASH] for maintenance.
←
PRE PRT AFT
BREAK **° C **° C
A heater is disconnected.
(This example shows that pre-
heater is disconnected.)
Contact your local distributor to call
for service.
1. Check that the heaters work properly
with [#TEST] - [HEATER TEST].
2. Make sure that connection of the
cables is correct.
3. Make sure that fuse of power supply
PCB is not blown out.
4. Replace the power supply PCB or
main PCB with a new one.
PRE PRT AFT
THERM **° C **° C
The thermistor of a heater is
defective.
(This example shows that the
thermistor of pre-heater is
defective.)
Contact your local distributor to call
for service.
1. Check that the heaters work properly
with [#TEST] - [HEATER TEST].
2. Make sure that connection of ther-
mistor is correct.
3. Replace the main PCB with a new
one.
<LOCAL.1> [#01]
NEAR END MCYK
Ink for one supply path has
been nearly used up.
Replace the ink cartridge for the supply
path corresponding to the indicated
color.
* Printing is permitted without
replacing the ink cartridge (until
INK END is displayed). However,
the printer returns to local mode
every completion of printing one
file.
←
*REMOTE.1* [#01]
NEAR END MCYK