Specifications

Color Inkjet Printer JV33-130/160
4-4
4-2. Troubles for which error messages are displayed
4-2-1. Error messages and corrective measures
<Error messages and corrective measures >
Display
Cause
Remedy (instruction & maintenance manual)
ERROR
No.
ERROR
Descriptions in the manual
(for reference)
Remedy
ERROR
01
MAIN ROM An error occurred on the
control circuit board.
(ROM)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Replace the main PCB with a new one.
ERROR
02
MAIN RAM An error occurred on the
control circuit board.
(RAM)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
ERROR
03
POWER +5V An error occurred on the
control circuit board.
(Power supply voltage
+5V)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Replace the power supply PCB with a new
one.
2. Replace the main PCB with a new one.
POWER +24V An error occurred on the
control circuit board.
(Power supply voltage
+24V)
POWER +42V An error occurred on the
control circuit board.
(Power supply voltage
+42V)
ERROR
04
FLASH ROM An error occurred on the
control circuit board.
(Parameter ROM)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. After uploading parameters, initialize all
parameters.
* If the state is not restored, replace the main
PCB with a new one.
ERROR
06
SD-RAM An error occurred on the
control circuit board.
(SDRAM)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Replace the main PCB with a new one.
2. Replace the PRAM PCB with a new one.
ERROR
07
HEAD (----) An error was detected in
the head connection.
(Abnormal temperature
was detected)
Turn the main power OFF and turn the
main power ON after elapse of 2~3
minutes. In a case of recurrence, con-
tact your local distributor to call for
service.
1. Reconfirm the head temperature with
[#TEST] - [TEMPERATURE.CHK] -
[NOZZLE TEMP].
In case of recurrence, execute the follow-
ings.
2. Make sure that corresponding FPC, main
FPC are connected in the right way.
3. Replace the corresponding head with a
new one.
4. Replace the ink slider PCB with a new
one.
5. Replace the main PCB with a new one.
VOLTAGE (----) An error was detected in
the head connection.
(Abnormal voltage was
detected)