Specifications

Color Inkjet Printer JV33-130/160
3-50
3-7-3. Adjustment of the station height
Adjustment of the wiper height
1 Remove the front cover (x4 screws) and the station cover (x5 screws). (See P. 3 - 4 )
2 Loosen the wiper height adjusting
screws (x2), and temporarily adjust the
screws until the thickness gauge is 8mm.
3 Loosen the screws (x2) on the front of
the head cover, and then tighten the
screws while holding the height adjust-
ment lever in the lowest position to fix
the head in place.
4 Move the head, and adjust the wiper so
that there is approximately 1 mm from
the nozzle surface.
Height adjustment lever
8mm
Screw for adjusting the wiper
Nozzle surface
1mm
wiper