Specifications

Overhaul of Other Parts
3-47
5 Adjust the cutter unit position back-
front.
Decide the unit’s lengthwise position so that the
cutter tool meets the slot (with push down the
cutter tool), and fix it with a screw.
* Cutter tool positioning slot has width wider than
that of the tool. Adjust the position within the
range.
* When there is no jig, push down the cutter tool
assembly to the platen face and adjust using the
cutter slot of platen.
6 Move the head unit to each right, center and left end on the platen, and push down the cutter tool
assembly to check back-front positioning.
* On rare occasions, the tool comes out of the slot because of assembling accident errors or differences of part accuracies. In
such a case, adjust again to the back-front optimum position where the tool is always in whole slot on the platen.
7 Attach the covers.
Reverse the disassembly procedure for reassembly.