Specifications

Color Inkjet Printer JV33-130/160
3-46
4 Remove the screws (x3), then remove the
cutter unit.
5 Reattach by reversing the removal pro-
cedure.
Cutter Unit Positioning
1 Set screws (x3) of the cutter unit at temporary joint state.
Temporary joint state is that the unit is held lightly.
2 Down the Clamp Lever.
Keep clamp lever down while adjusting. PG setting should be 1.5 mm or less.
3 Set the Jig to the Platen.
Place the jig base pin (x3) in the slots in the back and front for platen media plate.
4 Push the jig to the end of the head.
After setting, slide the jig to the head end (to
stop).
If the jig cannot be arranged, using an intervenient having height of 7.0 mm of the cutter unit side is
allowed.
Cutter unit
To the end
Jig No. (G002842)