Specifications

Color Inkjet Printer JV33-130/160
3-40
4 Loosen the screws (x2) of the Y-SP plate
on the left side panel, and release the
tension from the Y drive belt.
5 At the belt connection points, remove
the left and right side belt holder 1 from
the belt holders.
6 Remove the belt holder 1 screws.
7 Pry open the belt holder 1 with a slotted
screwdriver or similar, then slide to
detach from the belt.
8 Use rubber tape or similar to stick
together the ends of the old belt and the
new belt, and perform one revolution of
the belt.
9 Once the belt has made one revolution, remove the joining tape and pass the belt through the rear
side of the slider.
Y drive belt
Belt holder (M400161)
Do not remove the screw
Belt holder 1
New belt
Tape
Make a circle
with belt