Setup guide

– 5.8 –

If “X DIRECTION” has been selected )

• Be sure to perform this item upon completion of media correction.

1) Press the

ENTER

key to start plotting.

To enter the correction value without performing

plotting, press the

key.

2) When plotting has been completed, correction

value input mode is entered.

Input the correction value using the

key.

Enter the correction value with the

ENTER

key.

In the same way, enter the correction values for

between heads 1 and 2 and between heads 1 and 3.

• Enter such a value the right and left

protrusions of the plotted pattern

agree with each otehr, 4 or less.

#PRN. adjust2

SEL. : X DIRECTION

#PRN. adjust2

X DIR1-2 : 0-0

If “BASIS SET” has been selected )

BASIS SET is a function which sets correction values for Variable-1, Normal-1, and Normal-

2 based on the correction value for Variable-2.

• Prior to BASIS SET, it is necessary to match correction values Y Si, Y Re, and Y

Bi for Variable-2.

• After BASIS SET, the correction values for Variable-1, Normal-1, and Normal-2

can be fine-adjusted using FINE.

1) Select the “BASIS SET”.

2) Press the

ENTER

key to make automatic

internal setup of correction values for other

waveforms.

#PRN. adjust2

SEL. : BASIS SET

#PRN. adjust2

BASIS SET : ent