Setup guide

– 5.6 –
5-3. Menu of #ADJUST
5-3-1. PRINTadjust2
This function is used to adjust the relative dot positions between heads after the nozzle BKT
has been replaced.
[Function]
Corrects the dot shot timing between heads into the X and Y directions based on black of the
Head 1.
Correction items and units entered are shown below.
X PRINT Y SINGLE Y REPEAT Y BI-D
between heads colors 1 - 2 1 dot units 0.1 dot units 0.1 dot units none
colors 1 - 3 1 dot units 0.1 dot units 0.1 dot units none
colors 1 - 1 none none none 0.1 dot units
• When this operation is executed, the adjustment values of the “PRINTadjust” which
is open to the user become the initial values. This is so that the adjustment values
obtained with this function can be used as a base to which the user correction
values can be added to obtain the actual dot position correction values.
The correction values are stored under the adijut parameters.
[Operation]
1) Select the “ADJUSTMENT.”
Press the
ENTER
key.
2) Select the “PRN.adjust2” pressing the
FUNCTION
key.
Press the
ENTER
key.
3) Select the item to be corrected using the
or key.
Press the
ENTER
key.
• “ADJUST: TEST DRAW” only plots
the test pattern that is used to check
the adjustments. There is no place
to enter correction values.
• If “ADJUST: FINE” is selected, refer
to the section “If FINE has been
selected” below.
#PRN. adjust2
SEL. : X DIRECTION
#PRN. adjust2
SEL. : Variable-1
#PRN. adjust2
SEL. : Variable-2
#PRN. adjust2
SEL. : Normal-1
#PRN. adjust2
SEL. : Noramal-2
#PRN. adjust2
SEL. : BASIS SET
FUNCTION
# ADJUST < ENT >
#ADJUST
PRN. adjust 2 < e n t >