Setup guide

– iii –
3-3. Troubles for which error messages are not given on the LCD .................................. 3.9
3-3-1. The device will not be energized. ......................................................................... 3.9
3-3-2. The device fails to perform plotting ................................................................... 3.10
3-3-3. Cutting failure..................................................................................................... 3.11
3-3-4. Faulty cutter ........................................................................................................ 3.12
3-3-5. Fan motor ........................................................................................................... 3.13
3-3-6. Abnormal nozzle discharge ................................................................................ 3.13
3-3-7. Abnormal ink shot .............................................................................................. 3.14
3-3-8. Ink-filling cannot be performed ......................................................................... 3.14
3-3-10. Abnormal heater temperature ........................................................................... 3.15
3-3-9. Abnormal wiper operation.................................................................................. 3.15
3-3-11. Cannot read the IC. ........................................................................................... 3.16
3-4. Plotting failure .............................................................................................................. 3.17
3-4-1. Print is not sharp ................................................................................................. 3.17
3-4-2. Abnormal print ................................................................................................... 3.18
3-4-3. Color of print is pale ........................................................................................... 3.19
3-4-4. Plotted drawing is out of position....................................................................... 3.19
3-4-5. Plotted dots or lines are dirty .............................................................................. 3.20
3-4-6. Stripes are always drawn at the time of scanning .............................................. 3.21
3-4-7. Black and White Stripes appear from side to side.............................................. 3.22
3-4-8. Banding (wind repples) ...................................................................................... 3.23
3-4-9. Dark and Light Images Occur at Each Scan ....................................................... 3.24
3-4-10. Banding occur................................................................................................... 3.25
3-4-11. Vertical stripes .................................................................................................. 3.25
3-4-12. Unstable heater temperature .............................................................................. 3.26
3-4-13. Ink drop or mist ................................................................................................. 3.26
CHAPTER 4 ADJUSTMENT
4-1. Maintenance Flow by Replacement Parts ................................................................... 4.3
4-2. Maintenance item ........................................................................................................... 4.4
4-2-1. Adjustment of the X-motor coupling ................................................................... 4.4
4-2-2. Washing a single S-Print head assy ...................................................................... 4.5
4-2-3. Replacement S-Print head assy. ........................................................................... 4.6
4-2-4. Adjustment of the head angle ............................................................................... 4.7
4-2-5. Adjustment of the head unit ................................................................................. 4.9
4-2-6. Replacement S-pump assy. (Periodical replacement) ........................................ 4.10
4-2-7. Adjustment of the station position...................................................................... 4.11
4-2-8. Replacement of the cap ...................................................................................... 4.14
4-2-9. Adjustment of the cutter height .......................................................................... 4.15